7.5 ON/OFF Timing Setting
With this function, the heat pump can turn on or turn off automatically at the set time.
When the time point of “Timer on” is arrived, the heat pump starts; thereafter, the “ON/OFF” could be controlled
automatically based on the setting temperature.
When the time point of “Timer off” is arrived, the heat pump is shut down; subsequently, the machine could no longer be
controlled automatically based on the setting temperature; it will be restarted until the next time point of “Timer on” is
arrived or the key is pressed.
Below examples show how to set the heat pump to switch on at 9:10 and switch off at 12:30.
Step 2
Flash
Flashing
Flashing
Step 3
Step 4
Flashing
Step 5
Flashing
Step 6
Step 1
Press to start ON time
setting.
Press again to select hour
and the hour value flashes.
Press or to adjust
the hour value.
Press or to adjust
the minute value.
Press to confirm the value and
turn to normal display.
Press to select minute and
the minute value flashes.
please turn to
the next page
Hot Water Series
19
Totally 1 ON/OFF timers can be set. And they can be applied to use for every day or only one day.
In timer setting status, the figure below NO. represents the timer sequence. If it shows “--:---“ on bottom, it means
timer invalid.
To cancel the timer, please refer to the instruction for timer setting and set it to be “---:---“
NOTICE
To Next Page
Loading...
