Need help?Do you have a question about the Firepower FP-55 and is the answer not in the manual?
Defines and categorizes notes, cautions, and warnings used in the manual.
Discusses general safety warnings related to plasma arc cutting and electric shock.
Details risks from plasma arc rays and noise, and protective measures.
Provides guidance on choosing a location, unpacking, and safely lifting the equipment.
Explains how to connect the power supply to input power and the gas supply.
Provides instructions for connecting torch leads and grounding for mechanized systems.
Outlines pre-operation checks and the step-by-step process for operating the system.
Lists common problems encountered during operation with potential causes.
Explains how to use the troubleshooting guide and addresses specific operational issues.
General| Series | Firepower |
|---|---|
| Model | FP-55 |
| Maximum Power | 550W |
| Output Power | 550W |
| Input Voltage | 100-240V |
| Input Frequency | 50-60Hz |
| -12V | 0.3A |
| +5Vsb | 2.5A |
| 80 Plus Certification | 80 Plus Bronze |
| Form Factor | ATX |
| Output Voltage | +3.3V, +5V, +12V, -12V, +5Vsb |
| Efficiency | 85% |
| Operating Temperature | 0°C to 40°C |
| Dimensions | 150mm x 140mm x 86mm |
| Connectors | 1x 24-pin ATX, 6x SATA |
| Output Current | 0.3A, 2.5A |
To Next Page
