Page 22
English Customer Service: 1-844-FIRMAN1
9. Press and hold the engine switch in the "START"(ll)
position for few seconds and release the switch to the
"RUN"(l) position.
10. Push the choke button to the “RUN” position.
8. Pull the choke lever out to the "CHOKE" position.
6. Flip the engine switch to the “RUN"(l) position.
7. Push the battery power restore switch for about
3 seconds and then release.
11. Allow generator to run at no load for few
minutes upon each initial start-up to permit
engine and generator to stablize.
Starting the Generator (Electric Start-LPG)
1. Before starting the generator, check for loose
or missing parts and for any damage which
may have occurred during shipment.
2. Check oil level.
4. Fully open the LPG cylinder knob.
Use your fingers, slide the outer barrel back on
the LPG quick connect hose fitting. While the outer
barrel is in the back position, insert the LPG hose
(included) into the inlet and release the outer barrel.
The barrel will automatically return and lock the
hose in the inlet.
3. Connect the regulator(A) to both LPG cylinder
and generator. Connect the power cord(B) to the
LPG regulator port. See “Connecting liquid
Petroleum Gas(LPG/Propane) ” section
on page 13,14 and 15.
Cylinder
NOTE: hen the fuel
selector switch is in “GAS”position(4:30 o’clock).
The gasoline valve is OPEN, w
To close this valve, turn the slector switch to the
“ LPG” position (1.30 o’clock).
NOTE: The generator will NOT start with LPG without
battery power or an appropriate connection.
5. Turn the fuel selector switch to “LPG” position(1:30 o’clock).
To Next Page
Loading...
