EasyManuals Logo

First Alert Onelink Safe & Sound User Manual

First Alert Onelink Safe & Sound
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
26
Modular Devices FCC and
Compliance Statements
OEM Responsibilities to Comply With FCC Regulations
The A76F Module has been certied for integration into products only by OEM integrators under the following condition:
1. The transmitter module must not be co-located or operating in
conjunction with any other antenna or transmitter.
As long as the condition above is met, further transmitter testing will not be required. However, the OEM
integrator is still responsible for testing their end-product for any additional compliance requirements required
with this module installed (for example, digital device emissions, PC peripheral requirements, etc.).
!
IMPORTANT: In the event that these conditions cannot be met (for certain
congurations or co-location with another transmitter), then the FCC authorizations
are no longer considered valid and the FCC ID cannot be used on the final product. In
these circumstances, the OEM integrator will be responsible for re-evaluating the end
product (including the transmitter) and obtaining a separate FCC authorization.
End Product Labeling
The A76F Module is labeled with its own FCC ID. If the FCC ID is not visible when the module is installed inside
another device, then the outside of the device into which the module is installed must also display a label referring
to the enclosed module. In that case, the final end product must be labeled in a visible area with the following:
“Contains Transmitter Modules FCC ID: 2ANOG-A76F
Or
“Contains FCC ID: 2ANOG-A76F
The OEM of the A76F Module must only use the approved antenna(s) listed above, which have been certified
with this module. The OEM integrator has to be aware not to provide information to the end user regarding how
to install or remove this RF module or change RF related parameters in the user manual of the end product.
To comply with FCC RF radiation exposure limits for general population, the antenna(s) used for this
transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the First Alert Onelink Safe & Sound and is the answer not in the manual?

First Alert Onelink Safe & Sound Specifications

General IconGeneral
BrandFirst Alert
ModelOnelink Safe & Sound
CategorySecurity System
LanguageEnglish

Related product manuals