What to do if my First Degree Fitness Equipment Trident Challenge AR Computer screen illuminates, but does not register when rowing?
If the Trident Challenge AR computer screen illuminates but doesn't register your rowing, the issue might stem from a loose or failed connection. First, ensure that the computer lead is securely connected. If the problem persists after confirming the connection, contact your local service center.
Why First Degree Fitness Equipment Trident Challenge AR computer does not illuminate after battery installation?
If the Trident Challenge AR computer does not illuminate after installing batteries, the batteries may be installed incorrectly or need replacing. Reinstall the batteries in the correct position. If the LCD screen still doesn't illuminate, try slightly rotating the batteries. If it still fails, contact your local service center.
What to do if the front of my First Degree Fitness Equipment rower lifts slightly during vigorous rowing?
If the front of your First Degree Fitness rower lifts slightly during vigorous rowing, it could be that the M10X150mm Vertical Seat Rail Tensioning Bolt is a bit too loose. Try tightening the bolt by a 1/2 turn, and then row again to test. Continue tightening as needed until the issue is resolved. Be careful not to over-tighten, as this can damage the seat rail. Only make small adjustments until the problem is corrected.
General| Type | Rowing Machine |
|---|---|
| Frame Material | Steel |
| Weight Capacity | 150 kg |
| Drive System | Belt |
| Resistance Levels | Adjustable |
| Warranty | 2 Years Parts |
| Flywheel Weight | 5 kg |
| Monitor | Multi-level computer monitor |
To Next Page
