Introduction CM6000
CM6000 Install Guide
Alarm and Starter System
www.firstechonline.com | www.compustar.com
Thank you for purchasing this Firstech system for your vehicle. The following installation manual is intended
for experienced and authorized Firstech technicians. We highly recommend that you contact your local
Firstech dealer and seek professional installation. Call 888-820-3690 or visit our websites at www.
compustar.com to locate your nearest dealer. If you need additional or replacement remotes and/or online
support please visit www.compustar.com/dealersupport.
Caution: The Manufacturer’s warranty will be void if this product is installed by anyone other than an
authorized Firstech dealer. Firstech provides installation support services to authorized dealers only.
This manual may change frequently. Please check www.compustar.com/dealersupport for updates.
Kit Contents CM6000
All Firstech FT-6000AS CONT controllers include the following:
- CM6000 main control module
- Wiring diagram sheet
- Main ignition wiring harness with two external relays
- Wiring harnesses
- Hood pin
- Mountable bright blue LED
- Firstech dual stage shock sensor
RF Kits with remote(s), Antenna, and Antenna Cable are not included with the FT-6000AS CONT.
The following sensors are available but not included with every system:
- Remote pager sensor (FT-RPS TOUCH) or (FT-RPS-2)
- Secure valet switch (FT-VALET GREY)
- Thermister temperature sensor (FT-TEMP SENSOR) (Drone and 2 Way remote LCD systems)
- DAS sensor (FT-DAS)
The remote(s) and antenna are modular and are not specific to the control modules. You have the ability
to pair almost any Firstech remote(s) and antenna receiver to the CM6000. This includes all 4 and 6 pin
antennas.
Any questions on contents please contact your distributor or us directly at 1.888.820.3690, Monday
through Friday, 8 AM to 5 PM Pacific Time.
Copyright 2011 Firstech, LLC.
Page 4
To Next Page
Loading...