General System Functions
Cancelling Reservation Mode
Reservation mode will be cancelled for the following reasons;
You did not activate the parking brake prior to turning off the ignition. You pressed the foot brake after the key was removed from the ignition.
You released the parking brake after the key was removed from the ignition.
You entered valet mode, opened the vehicle’s door, hood, trunk or set off the alarm.
Reservation Mode Settings
Reservation mode settings can be programmed with Option 1-6. It is recommended that reservation mode settings are programmed by your local authorized
Firstech dealer.
Default1 : Locks doors when reservation mode is set.
Option2 : Hold Key/Start button to initiate Reservation Mode
Option3 : Reservation mode sets 10 seconds after the last door is closed, as opposed to immediately.
This option will allow you to access the vehicle’s rear doors, trunk or hatch prior to the system setting reservation and passively locking/arming.
Hold button for 2.5 seconds to release the trunk or hatch. If you are in range, the remote will beep twice and the trunk icon will
flash indicating that the trunk release command has been successfully transmitted. Your doors will also unlock.
IMPORTANT: Trunk release is an optional vehicle feature that may require additional parts and labor.
Trunk Release
General System Functions
Your system is equipped with two additional outputs that can be configured to control windows, open power sliding doors, open a power sliding
moon roof, or even turn on a rear defroster. These outputs can be configured for pulsed, timed or latched settings. You also have the option to control
up to 5 additional outputs for a total of 7. Your authorized Firstech dealer can set these outputs up accordingly. Using auxiliary outputs to control
additional vehicle functions will require additional parts and labor.
Please see the Auxiliary Channel Table for details. Tap the button to trigger secure auxiliary and then tap for a half second to trigger
auxiliary output 1. Tap the button and then hold the buttons for 2.5 seconds and then tap button for a half second to trigger
auxiliary output 2. The vehicle’s parking lights will flash once and/or siren chirp once indicating that the auxiliary outputs have been triggered.
By default, the system is in Secure Auxiliary Mode, which requires you to tap button for a half second prior to triggering auxiliary 1 or 2. To turn
off secure auxiliary, ask your authorized Firstech dealer to turn on Option 4-5 to setting II.
If you have to control up to 7 auxiliaries, there are additional steps to follow. Please see the Auxiliary Channel Table for details.
By Firstech, LLC 22
23 By Firstech, LLC
Auxiliary Outputs/Window Roll-Down/Sliding Doors
FT-2WLCD-S-E_UserGuide.indd 23-24 2011-6-10 12:05:44
To Next Page
Loading...
Need help?
General
