Advanced System Functions
Tap buttons simultaneously for a half second to turn drive lock on and off (also known as ignition controlled door locks). The
vehicle’s parking lights will flash once and/or siren chirp once to confirm drive lock is off. The vehicle s parking lights will flash twice
and/or siren chirp twice to confirm drive lock is on.
IMPORTANT: Drive lock mode requires that the dealer turn on Option 1-9. Drive lock has three settings;
Default 1: Off
Option 2: Locks the doors when the ignition is on and after the brake is depressed.
Option 3: Locks the doors when the RPM s have reached two times that of idle speed (this setting requires that a tachometer wire is connected).
With both settings, the doors will unlock when the ignition is turned off. If using this feature on a manual transmission vehicle, the doors will unlock
upon setting the emergency / parking brake.
The following section reviews advanced system functions. Many of these functions require multiple steps or additional programming by your local
authorized Firstech dealer to be active.
d@l@O@@c@d@l
t@t@m
This feature can not be turned on with the 2 Way remote. The built in turbo timer keeps the vehicle’s engine running for either 1, 2, or 4
minutes (programmable from dealer) after the vehicle key has been removed from the ignition. This feature will keep oil running through
the turbo system to allow for appropriate cooling time. Tap buttons simultaneously for a half second to turn on or off turbo
mode. The remote will beep once and the turbo icon will illuminate to confirm that turbo mode is activated. The remote will beep twice
and icon will disappear to confirm turbo mode is off.
IMPORTANT: To utilize this feature, the emergency / parking brake wire must be connected to the Firstech system. Consult your local authorized
dealer for installation.
By Firstech, LLC 16
General System Functions
Your system is equipped with two additional outputs that can be configured to control windows, open power sliding doors, open a power sliding moon
roof, or even turn on a rear defroster. These outputs can be configured for pulsed, timed or latched settings. Your authorized Firstech dealer can set
these outputs up accordingly. Using auxiliary outputs to control additional vehicle functions will require additional parts and can be rather labor
extensive.
Tap button for a half second to trigger auxiliary output 1. Tap button for a half second to trigger auxiliary output 2. The vehicle
s parking lights will flash once and/or siren chirp once indicating that the auxiliary outputs have been triggered.
By default, the system is in Secure Auxiliary Mode, which requires you to hold buttons for 2.5 seconds prior to triggering auxiliary 1 or 2. To
turn off secure auxiliary, ask your authorized Firstech dealer to turn on Option 4-5 to setting II.
a@o@O@w@rMd@O@s@d
Only available on alarm/starter and alarm systems. Upon lock/arm and unlock/disarm, you can eliminate vehicle’s audible
confirmation by muting the siren. Normally, the siren will chirp once to indicate the system is locked/armed and twice to indicate the
system is unlocked/disarmed. To mute the siren tap buttons simultaneously for a half second.
s@a@O@d
17 By Firstech, LLC
To Next Page
Loading...
Need help?
General
