ADDITIONAL SAFETY RULES FOR LOG SPLITTERS
_ ARNING: DO NOT OPERATE YOUR LOG SPLITTER UNTIL IT IS COMPLETELY
ASSEMBLED AND INSTALLED ACCORDING TO THE INSTRUCTIONS.
1. If you are not thoroughly familiar with the operation of
a log splitter, obtain advice from your supervisor, instructor
or other qualified person.
2. Make sure wiring codes and recommended electrical
connection instructions are followed, and that the machine
is properly grounded.
3. Make all adjustments with the power off.
4. Machine must be positioned on a solid work surface
before using.
5. Do not split wood larger than the recommended
capacity. If jam should occur, release motor switch
button and use pry bar to remove jammed log.
NEVER use your hands.
6. Do not try to remove split logs until the unit has totally
completed work cycle.
7. Stack logs as you work. This will provide a safer,
uncluttered work area.
8. Disconnect machine from the power source when
making repairs.
9. Replace all guards after servicing.
10. Before leaving the machine, make sure the work area
is clean.
To Next Page
Loading...