6. In the center of the filter plate there are two rings. Turn the outer ring anticlockwise, about a 1/8 turn. This will
release the filter plate.
7. Lift the filter plate out. Remove any foreign material, wash in hot soapy water and rinse thoroughly in clean water,
then wipe with a damp cloth. Take care handling the sharp outer edge of the filter plate.
To Replace the Filter Plate and Spray Arm
8. Before replacing the filter plate, ensure the O-ring is correctly
positioned on the base, as shown.
9. Orientate the filter plate and lower it into place: make sure its kidney
shaped hole aligns with the matching recess in the dishwasher base
10. Ensure the filter plate lies flat in the base, then lock it into position:
turn the outer ring clockwise until the the marks align with each other
and all three pin pairs firmly interlock, as shown.
https://producthelp.fisherpaykel.com/us/Clean/DishDrawer%E2%84%A2/Double/DD24DCB7/User_Guide_DD24DCB7/11_Us…
Updated: Wed, 23 Jun 2021 05:56:08 GMT
Powered by
4
To Next Page
Loading...
