How to attend to a fault - Classic models
UT@
l
U1
No water - the water supply hasn't been
turned on.
U4 FauJt in the other drawer preventing the
II II
U -t use of this drawer.
I t L-- U6 The spray arm has loosened or come off
e_e0 its mounting, or water pressure is too
low.
E1 Flood detected.
ET"
E2 Motor fault.
L__7\
cc
L--_-I _" E3 Temperature sensor fault. You may need
ZS to have a tempering valve installed
on your water supply, to ensure that
incoming water is less than 65°C (149°F).
E4 Heating element failed.
L--It\
E5 Fault with the internal lid of the
L--L--_,
C Ze dishwasher.
CO
E6 Fault with the drying fan.
E7 Electronics fault--detergent dispensing
L--'_\
C I system.
E8 Electronics fault--other systems.
L--S,_\
Cez_
E9 Electronics fault--controller.
L--LT\
CZe
EC Electronics fault--communication
L--S-\
C a_ between drawers.
To Next Page
Loading...
