Fisher & Paykel DISHDRAWER DD24DAX9 User Manual

Troubleshooting
Excessive water remaining above the filter plate, after the rinse cycle. (This is displayed as
an
fault)
• Check for a kinked drain hose, blocked waste connection, highloop not properly installed, drain hose not routed
correctly or spray arms not in place.
No water supply. (This is displayed as an
fault )
• Check water is connected and turned on.
The dishwasher is beeping continuously
• There is a fault. See section ‘If there is a fault’ in the User guide for further information and instructions.
No program indicator lights up when the drawer is opened
• Ensure power is connected and is switched on. If it is and still no indicator lights up, see the ‘Preference options’
section of the ‘Quick start guide’. An option called ‘Open drawer auto power-on’ may need to be turned on.
Water around water supply and drainage connections
• Check connections, existing plumbing and hoses for leaks. Check rubber washer and hose clamp are correctly
fitted.
If product is tipping
• Ensure the product is secured to the cabinetry.
https://producthelp.fisherpaykel.com/us/Clean/DishDrawer%E2%84%A2/Double/DD24DAX9/Installation_Guide_DD24DAX9/1…
Updated: Tue, 16 Nov 2021 11:53:15 GMT
Powered by
1

Fisher & Paykel DISHDRAWER DD24DAX9 Specifications

General

Model Number	DD24DAX9
Noise Level	44 dBA
Dimensions (H x W x D)	820 x 600 x 573 mm
Finish	Stainless Steel
Size	Standard
Control Type	Electronic
Number of Wash Cycles	15
ENERGY STAR Certified	Yes
Material	Stainless Steel
Width	600 mm
Height	820 mm
Color	Stainless Steel
Installation Type	Built-in
Product Type	DishDrawer
Features	Delay Start
Drying System	Fan assisted drying

Summary

Dishwasher Troubleshooting Guide

Excessive Water After Rinse Cycle

Excess water above filter plate after rinse cycle, indicated by A3 fault. Check drain hose and spray arms.

No Water Supply

No water supply indicated by A1 fault. Check water connection and supply is turned on.

Continuous Beeping

Dishwasher beeps continuously, indicating a fault. Refer to the User guide's 'If there is a fault' section.

No Indicator Lights When Drawer Opened

No program lights appear when drawer opens. Check power or 'Open drawer auto power-on' setting.

Water Leaks at Connections

Water around supply and drainage connections. Check hose fittings, plumbing, and clamps for leaks.

Product Tipping

Product tipping issue. Ensure it is secured to the cabinetry properly.

Misaligned Front Panels

Front panels are misaligned. Check cabinetry squareness and adjust front panel alignment.

Drawer Not Closing Properly

Drawer does not close properly. Check for obstructions or consult the User guide.