_ INSTALLATIONINSTRUCTIONS
DishDrawer ®
STEP9: MEASURING THE TOEKICK (DOUBLEMODELS ONLY)
!_1 Partially the bottom drawer, Turn Prefinished Toe Kick
open
upside down and hold vertically against the bottom edge of the
Tub side (not the drawer front),
Mark the position of the bottom edge of the Tub side on the Toe Kick,
Choose the nearest groove to the pencil mark which will result
in the shortest Toe Kick.
STEP10: TRIMMING THETOEKICK (DOUBLE MODELS ONLY)
!
Important!
Before cutting ensure the Toe Kick is positioned on a wooden
chopping board to avoid damage to surrounding area.
I_On the chosen groove cut down the vertical ribs at the centre and
the ends using a knife, Cut along full length with a knife, Turn Toe
Kick over, bend and then cut from front, Sand or scrape bottom edge
to remove rough patches,
_WARNING!
Remove all sharp edges
l_To avoid a cutting hazard remove a//sharp edges after trimming,
I_ Remove Toe Kick tabs by snapping them off.
To Next Page
Loading...
