,,- BEFOREYOUSTART- DOUBLE& S/NG£E MODELS
DishDrawer ®
|_ft_k"]!,_lP.,P.,ill.'ll]
r
DOUBLEMODELS
E_.... : ......... __ _ ...........
FlexibleExtrusion FlexibleExtrusion
for Sides (2) for Top(7)
Clamp
EdgeProtector (7)
@)
(7) Washer
Drain Hose DrainHose Wire
Support (7) Joiner (7) Clips(2)
Installation Tabs (2)
Phillips 76mm
Screws (7)
Moisture
Protection
Tape(1)
p/n 527208
I[eIe]!._r#lIlln]llnJ
Prefinished
ToeKick (I)
White prefinishedtoe kick kit pin 526678
or Blackprefinished toe kickkit pin 526679
or Iridiumprefinished toekick kit pin 527109
• J
F
%NGLEMODELS
iMm <::' !!!!!!!!!!!!!!!!I_=_'_=_'"_'"_"_";'Phillips 1ram
[tolllo_ (1)
Pm ction
L}_aklllos_
Iq _x%I Exuz s_o,_Ic>_Skl s (?)
Wooden Chopping Board
Tape Measure
Spirit Level
Safety Glasses
Utility Knife
Pencil
Sandpaper
Drill& No.2Phillips Bit
No,2Phillips Screwdriver
FlatScrewdriver
Adjustable Wrench or M5 Socket
011/2" (38mm) Hole Saw
SideCutting Pliers
SPARE PARTS INSTALLATION KIT FOR SINGLE& DOUBLE MODELS: pin 526676
lllVk_lP.fl l,.lll [llArl ,.Itlll ,.i,.It!,.lll [lll v|
ELECTRICALPREPARATION
,4) Theswitched power outlet must be outsidethe DishDrawer®
cavity so that it is accessibleafter installation,
B) Theswitched power outlet must be between 6" (150mm)and
18" (450mm)from the DishDrawer® cavity.
¢) Referto Page9, Step 5 for electricalconnection options,
Important!
The services hole in the DishDrawer® cavity needsto be large
enoughfor the plugonthe power supply cordto fit through,but MUST
NOTbe more than 11/{' (38ram).
PLUMBING & DRAINAGE PREPARATION
,4) A readilyaccessiblevalve must be installed in the water supply pipe.
B) If the supply pressureexceeds145 psi (lO00kPa),then apressure
limiting valvemust be used,
C) Review PlumbingOptionson pages4 or 6. Choosea methodthat best
suits your needs,
D) A DrainHoseextension Kit P/N 525798will extendthe drainhoses
by 1413/4"(3,6m), The kit is availablefrom the nearestFisher&Paykel
AuthorizedServiceAgent, DONOTextend beyondthis limit,
E) This Dishwasher'smaximumdrain heightis 37//2" (950mm).
e___lV.,'[_Jltl[_f|llVl,fl]tlA_V.,ll[IAw
POWER SUPPLY CORD
,4) Care should be taken when the appliance is installed or
removed to reduce the likelihood of damage to the power
supply cord,
B) If the power supply cord is damaged, it must be replaced by
the Manufacturer, Service Agent or a similarly qualified person
in order to avoid a hazard,
GROUNDING INSTRUCTIONS
,4) Thisappliancemust begrounded. Inthe event of malfunctionor
breakdown,groundingwill reducethe risk of electric shock by
providinga path of leastresistancefor electric current.
CAVITY PREPARATION
,4) It is recommended that all cabinetry surroundingthe DishDrawer®
(includingthe undersideof the countertop)is sealedwith anoil based
paint or moisture-proofpolyurethaneto prevent possiblesteam
damage, Theair in the cavity can get very hot and humid(saturated
at 122°F/50°C)
B) Theself-adhesivemoistureprotection tape must beappliedto the
undersideof the countertopto prevent moisturedamage,(referto
cavity diagrampg 3 or 5), Besuresurfacesare dry and dust-free
prior to application.
C) Be surethe cavity providessufficient materialto securethe DishDrawer®
using the mountingtabs (referto step 1, page7). If there is
nothing to screw to, add a brace. Seepage 3 or 5 for screw locations,
D) Theservices holeMUST be immediatelyadjacent to the rearlower
cornerof the cabinetry, If not, the hoseswill preventthe
DishDrawer® being pushedbackinto the cavity all the way, Thehole
can belocated oneither side dependingon the location of the
services.
E) Be surethe cavity sidesare plumb (vertical)as this will assist with
levellingthe DishDrawer®,
F) Minimum clearances:
Vs" (2,5mm)LIL
1/s" (2,5mm)
V2" (13mm)
Z_WARNING!
Improperconnectionof the equipment-groundingconductorcan result
in a risk of electric shock. Check with a qualifiedelectrician or
service representativeif youare indoubtas towhether the appliance
is properlygrounded.
B) Thisappliance is equippedwith a power supplycord having an
equipment-groundingconductorand an earthingplug, Thepower
supply plug must be pluggedinto an appropriateoutlet that is installed
and earthedin accordancewith all local Codesand Ordinances,
Z_WARNING!
Donot modifythe power supplyplugprovidedwith the appliance- if
it will not fit the outlet, havea properoutlet installedby aqualified
electrician. Do not usean extensioncord, adaptorplugor multiple
outletbox.
To Next Page
Loading...
