will be no surface to rest the rails on.
3. Position the appliance on the rails, making sure the
pins are correctly inserted in the housings, then fix
it with the screws supplied. If the height of the
appliance requires adjusting, use the spacer disks
provided.
4. If necessary, correct alignment of the appliance by
positioning the spacers supplied under or at the
sides of the support.
5. To lift the appliance in the front (max. 2mm) turn
the latch as shown.
https://producthelp.fisherpaykel.com/au/Cook/Companion_Products/Built-in_Coffee_Maker/EB60DSXB2/Installation_Guide_E…
Updated: Tue, 25 Aug 2020 02:00:06 GMT
Powered by
2
To Next Page
Loading...
