ElieclricaH ..... or Eliectic Modells Or liy
£_÷ctHc Shock Hazard
Use a new UL approved 3O-ampere power cord or direct wire
came.
Use a UL approved strain reJiefo
DBconnect power before making e[ec'trica[ connections.
Connect neutral wire (white or center wire) to center terminal
On aJ[ four wire installations remove the grounding [ink and
connect the ground wire to the green ground connecting screw,
Connect remaining 2 supply wires to remaining 2 terminals°
Securdy tighten aJ[dectrica[ connections.
Failure to do so can result in death, fire, or electrical shock.
Note:
]he wiring diagram is k::>catedin the controi console_
]i_e dryer must be piugged into or connected to an individuai ixanch circuit, do not use an
(_xter_sk:) N cerd
] hf__)ow__rsura_)bmust be220i 240\/or 208'\{ (30Hz apDmw<-iaitem afin q cure,nt ebctrica, i
ervice_ Ti_eeiectricai service re<suirementscan be found on ti_edata iabei ti_at is iocated on the /
Di_h bacL A 30 ampere rue or circuit breaker is required o!/each of tile iines i/i:
ira Dower cord is ued, the cord rout be Diuqqed into a 30 ampere rece_)lade 1i
]he Dower cord is NOT provided wid/US eiectric modei dryers
]i_is dryer is upplied witi_ ti_e cabinet grounded thrnugi/the neutrai on ti_e terminal bk>ck, i
if the dryer is tn ke installed in (I) a new branci_ circuit instaiBtk_r/, (2)a mobile i_orne, (9 a
recreatk:maiveificle, (4) a!/area where local code do !lot permit grounding through ti_e neutral
cnnductnr, the appliance gmu!/dk/g link mu_ be removed and a 4wire power cord/cable or a ]_
eparate grounding wire rout be ued
Do not reuse a _)owersu_)r_)ivcordicabie frnrn an oid dryer The raowercordicabie eiectric uD_)iv ]
wiring rout be retained at the dryer cabinet with a uit_bie Ui listed train relief
208V Requirements
/:
_r\/ic__r_Dms_r_tatiw_(co Acc_ssori_sDag__9 for kit Dart rmmb_r)
z' D ]
To Next Page
Loading...
