Customising Wash Cycle
Delay Start
The ‘Delay Start’ option enables you to delay the start of the wash cycle from between 5 minutes and 12 hours. Times
you can select are 5 min, 15 min, 30 min, 1 hour, then hourly up to 12 hours. This can be useful to time your washing to
finish when you arrive home from work, or to start once you have finished in the shower. Some stain removers also
require you to spray them on then leave for several minutes, before washing. Your washer will wait for the selected time
then start the cycle without any other inputs from you.
To Programme a ‘Delay Start’ time:
1. Touch the ‘More’
button to increase the delay time. The delay time will increase from 5 minutes up to 12 hours.
– If you hold the ‘More’
button down, the time displayed on the screen will increase after every half second (more convenient than
touching the button repetitively)
2. Touch the ‘Less’
button to decrease the time or turn ‘Delay Start’ off.
Once started, the time will count down on the display screen in 1 minute increments. The ‘Delay Start’ light will flash and
the
light will stop flashing and be on constantly.
https://producthelp.fisherpaykel.com/nz/Wash/Front_Loaders/WashSmart/WH1060P1/User_Guide_WH1060P1/11_Customisi…
Updated: Tue, 16 Nov 2021 12:17:21 GMT
Powered by
1
To Next Page
Need help?
General
