To Next PageTo Next Page
Need help?Do you have a question about the Fisher Labs M-Scope and is the answer not in the manual?
General| Depth Indicator | Yes |
|---|---|
| Intended Use | Relic Hunting |
| Technology | VLF (Very Low Frequency) |
| Power Source | Battery |
| Water Resistance | Coil is waterproof, control box is not |
| Battery Life | Approximately 25 hours |
| Target ID | Yes |
| Display Type | LCD |
Adjusts the audio output volume and beep rate for the device.
Configures the metal detection sensitivity level from 1 to 99.
Fine-tunes sensitivity for top, middle, and bottom detection zones.
Adjusts the contrast of the LCD display for better readability.
Explains how the M-Scope detects targets using infrared beams.
Details the "Speed Violation!" alarm for exceeding the speed limit.
Describes the "Photo Diode Blocked!" alarm for prolonged beam interruption.
Explains normal target detection without speed issues.
Shows how zone indicator lights display target signal strength and location.
Alerts when a keypad key is held down for too long.
Provides steps to safely power down the M-Scope unit.
Warns when the device battery voltage is critically low.
Discusses potential issues caused by external electromagnetic interference.
