• Loosen the screw in the battery compartment door with a
Phillips screwdriver.
• Remove the battery compartment door.
• Insert three new size “AAA” (LR03) alkaline batteries, as
indicated inside the battery compartment.
• Replace the battery compartment door and tighten the screw
with a Phillips screwdriver. Do not over-tighten.
Battery Information
• Do not mix old and new batteries.
• Do not mix different types of batteries: alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium).
• Remove the batteries during long periods of non-use. Always
remove exhausted batteries from the product. Battery leakage
and corrosion can damage the product.
• Never short circuit the battery terminals.
• Non-rechargeable batteries are not to be recharged.
• Only batteries of the same or equivalent type as recommended
in the “Battery Installation” instructions are to be used.
• If removable rechargeable batteries are used, they are only to
be charged under adult supervision.
• Rechargeable batteries are to be removed from the product
before they are charged.
• If you use a battery charger, it should be examined regularly
for damage to the cord, plug, enclosure and other parts. Do
not use a damaged battery charger until it has been properly
repaired.
Battery
Compartment
Door
1.5V x 3
“AAA” (LR03)
Cartridge Installation
Shown Actual Size
Cartridge
• Insert the cartridge into the viewer, as shown.
• Slide the cartridge lock to secure the cartridge in the viewer.
You will hear a sound when the cartridge is properly inserted
and secured.
Please keep small parts, such
as the “AAA” (LR03) batteries, out
of children’s reach.
CAUTION
Cartridge Lock
Viewer
To Next Page
Need help?
General
