Instruction Manual
D200138X012
3582, 582i, and 3583
February 2015
19
Figure 7. Typical Dimensions and Connections
11B6519‐G
11B6520‐F
C0775‐1
246.1
(9.69)
182.6
(7.19)
141.2
(5.56)
119.1
(4.69)
7.9
(.31)
289.0
(11.38)
8.6 (.34) ∅ HOLES
SPACED 17.5 (.69)
APART
139.7
(5.50)
57.2
(2.25)
12.7
(0.50)
261
(10.26)
141.2
(5.56)
127.0
(5.00)
7.9
(.31)
204.7
(8.06)
139.7
(5.50)
57.2
(2.25)
12.7
(.50)
mm
(INCH)
8.6 (.34) ∅ HOLES
SPACED 17.5 (.69)
APART
3582
(DIMENSIONS FOR 3582A, C, D, AND G ARE THE SAME)
C
L
OF ACTUATOR
1/4‐18 NPT
OUTLET CONN
PLUGGED
1/4‐18 NPT
OUTPUT CONN
1/4‐18 NPT
SUPPLY CONN
1/4‐18 NPT
OPTIONAL OUTPUT
CONN PLUGGED
3/8‐18 NPT
VENT CONN
1/2‐14 NPT
CONDUIT
CONN
1/4‐18 NPT
OUTLET CONN
PLUGGED
1/4‐18 NPT
SUPPLY CONN
3/8‐18 NPT
VENT CONN
1/4‐18 NPT
OUTPUT CONN
C
L
OF ACTUATOR
3582i
1/4‐18 NPT
OUTPUT CONN
CAUTION
Use a clean, dry, oil‐free air supply with instruments containing EPDM components. EPDM is subject to degradation when
exposed to petroleum‐based lubricants.
Supply pressure must be clean, dry, oil‐free air or noncorrosive gas. Use a 67CFR filter regulator with standard 5
micrometer filter, or equivalent, to filter and regulate supply air. Except for the 3582NS, the filter regulator can be
To Next Page
Loading...