Instruction Manual
D200138X012
3582, 582i, and 3583
February 2015
41
Parts List
Positioner/Transmitter Common
Parts (figure 21)
Note
Parts in the following list are common to both 3582 valve positioners
and 3583 position transmitters, unless identified by specific type
number.
Note
Part numbers are shown for recommended spares only. For part
numbers not shown, contact your Emerson Process Management sales
office.
Key Description Part Number
1 Case Assembly, Aluminum and PEEK
2* Shaft Assembly, SST/steel
For all except 3582NS and high vibration
For travel up to 54 mm (2.125 inch) 15A9609X012
For travel up to 102 mm (4 inch) 15A9609X022
For 3582NS and high vibration
For travel up to 54 mm (2.125 inch) 15A9609X102
For travel up to 102 mm (4 inch) 15A9609X112
3 Nozzle Adaptor, SST
4 Cam, SST
Cam A (For all types except 3582NS)
Cam B
(For all except 3582NS, 3583, 3583C)
Cam C
(For all except 3582NS, 3583, 3583C)
4 Cam, SST/nitride (for 3582NS and high vibration)
Cam A (for all types)
Cam B (For all except 3583, 3583C)
Cam C (For all except 3583, 3583C)
6 Cam Bolt, 416 SST
7* Bellows Assembly
Standard brass 13B8783X012
For sour gas 13B8783X022
8 Range Spring, pl steel (see table 9)
0.2 to 1.0 bar (3 to 15 psi)
0.4 to 2.0 bar (6 to 30 psi)
9 Spring Seat, aluminum
10 Machine Screw, pl steel
Key Description Part Number
11* O‐Ring
Std. const., Nitrile
All except 3582NS 1F463606992
Hi‐temp. const., Fluorocarbon
3582A, 3582C & 3583C 1N571406382
3582NS, EPDM Duro 80A 17B4784X012
12 Lockwasher, pl steel (2 req'd)
13 Machine Screw, pl steel (2 req'd)
18 Nozzle, SST
3582
3583
19 Flapper Sub‐Assembly
Note
Parts 19A through 19L are shown in figure 20.
19A Adjustment Arm, pl steel
19B Flapper, SST
19C Machine Screw, pl steel (2 req'd)
19D Flapper Arm, aluminum
19E Machine Screw, pl steel (2 req'd)
19F Flapper Spring, SST
19G Zero Adjustment Screw, 18‐8 SST/PEEK
19H Hex Nut, pl steel
19J Lockwasher, pl steel
19K Arm Support, SST
19L Pivot Pin, 440C SST
20 Setting Adjustment Gear,
All except 3582NS, nylon
3582NS, 316 SST
Figure 20. Flapper Sub‐Assembly (Key 19)
13A1451‐E
ASSEMBLE WITH LETTER
T ON THIS SURFACE
*Recommended spare parts
To Next Page
Loading...