Need help?Do you have a question about the Fisher 700-T and is the answer not in the manual?
General| Type | Solid State Receiver |
|---|---|
| Tuning Range | FM, MW |
| Frequency Response | 20Hz to 20kHz |
| Total Harmonic Distortion | 0.5% |
| Speaker Load Impedance | 4Ω to 16Ω |
| Input Sensitivity | 2.5mV (MM) |
| Signal to Noise Ratio | 80dB (line) |
| Inputs | Phono, Aux |
| Outputs | Headphones |
Steps for aligning the FM front end tuner circuits using test equipment.
Procedure for aligning the 10.7 MHz IF amplifier stages for gain and symmetry.
Steps to calibrate the FM tuning meter and adjust FM muting sensitivity.
Detailed steps for aligning the MPX decoder using RF signal and test points.
Alternative steps for MPX decoder alignment without RF signal connection.
Procedure to adjust the center voltage for power amplifier transistors.
Procedure to adjust the idling current for power amplifier output stages.
Diagram illustrating external component connections to the chassis.
Top and bottom views showing component placement on the chassis.
Procedures for testing power amplifier, distortion, and output measurements.
Instructions for dial cord stringing and mechanism adjustment.
Steps for replacing meter, stereo beacon, and dial pointer lamps.
Guidance for cleaning the dial glass and front panel.
To Next Page
