Fisher MT-6310 - Mounting the Cartridge; PICK-UP ARM HEIGHT ADJUSTMENT; PICK-UP RISING POSITION ADJUSTMENT

mete
ond
MOUNTING THE CARTRIDGE
. Carefully mount cartridge according to instructions
given by the cartridge manufacturer. Do not tighten
mounting screws as yet.
. Connect the four colored wires found in the cartridge
shell to the cartridge terminals. It is important that con-
nections are made correctly. That is, colors of wires and
cartridge terminals must be matched.
Red = Right output
Green = Right ground
White = Left output
Blue = Left ground
. Plug cartridge shell into tone arm and tighten cartridge
shell ring by turning it counterclockwise (as seen from
shell side).
.Move the tone arm over the overhang indicator and
adjust cartridge until the stylus point is located exactly
above the overhang indicator. Fix cartridge in this
location by tightening mounting screws.
PICK-UP ARM HEIGHT ADJUSTMENT
When using the cueing lever or the auto-return, perform
the pick-up arm height adjustments by turning each
adjusting screw as illustrated in Fig. 3.
Turn the adjusting screw clockwise to raise the Pick-up
Arm, and counter-clockwise to lower it.
PICK-UP RISING POSITION ADJUSTMENT (Return
Point)
Change the return point either to inward or outward by
turning the return adjusting cum (37).
~NEON LAMP P.C.BOARD
@
MOUNTING SCREW
TONE ARM
>
CARTRIDGE SHELL RING
CARTRIDGE SHELL
CARTRIDGE
Fig. 1
MOUNTING SCREW CARTRIDGE SHELL RING
2 — OVERHANG INDICATOR,
Fig. 2
PICK-UP ARM HEIGHT ADJUSTMENT
(when Cueing Lever is used)
PICK-UP ARM HEIGHT ADJUSTMENT
(when auto-return is used)
Fig. 3
SPEED SELECT P.C.BOARD .
emo e Tanase
|
czlo 0) 5°
o4 2 O| 40.
|
sat? oF 6 0 :
r—--4 Saree ie
a
eee ea Ne - Z
TT :
} | 2 6
boo oe
PUSHSW sit