Need help?Do you have a question about the Fisher RS-1060 and is the answer not in the manual?
General| Brand | Fisher |
|---|---|
| Model | RS-1060 |
| Category | Stereo Receiver |
| Language | English |
Procedure for testing harmonic distortion for both one and two channels.
Steps for removing the main chassis, cabinet components, and front panel assembly.
Procedures for removing various PC boards like RF/IF, EQ, Protector, and Power boards.
Procedures for removing meter, lamps, front end, and Dolby boards.
Lists of accessories, cabinet, and external appearance components.
List of chassis-mounted parts and their identification.
Comprehensive list of electrical components and their part numbers.
Detailed steps for removing the Power Amplifier P.C. Board assembly.
Instructions for removing power transistors from the board.
Procedure for aligning the AM tuning and RF/IF sections.
Procedure for aligning the FM tuning and IF/detector sections.
Procedure for aligning the FM Multiplex (MPX) section.
Illustrations of oscilloscope waveforms for alignment procedures.
Diagram and instructions for stringing the dial cord.
Covers initial setup, signal generator settings, and function selections.
Procedure for adjusting the FM Multipath frequency.
Prerequisites before commencing the FM Dolby adjustment.
Procedure to adjust the gain for the FM Dolby circuit.
Required function selector and switch settings for the test.
Graph showing the performance characteristic of the equalizer circuit.
Graph illustrating the tone control circuit's frequency response.
Description of the bass selector function and its frequency settings.
Procedure for adjusting voltage outputs on the power supply board.
Procedure for adjusting idling current on the power amplifier board.
To Next Page
