Need help?Do you have a question about the Fisher 800-T and is the answer not in the manual?
General| Frequency Response | 20Hz to 20kHz |
|---|---|
| Total Harmonic Distortion | 0.5% |
| Signal-to-Noise Ratio | 70dB (MM), 80dB (line) |
| Input Sensitivity | 2.5mV (MM) |
| Weight | 32 lbs |
| Tuning range | FM, AM |
| Output | 250mV (line) |
| Speaker load impedance | 4 to 16 ohms |
| Channel separation | 50dB (MM) |
Ensures the receiver is connected to the correct AC voltage and frequency matching its specifications.
Instructions for connecting and positioning the supplied AM and FM antennas for optimal reception.
Detailed steps for connecting main speakers, including phasing and impedance considerations.
How to turn the receiver on/off and adjust the listening volume for optimal sound.
Guide to selecting input sources like PHONO, FM, AM, or AUX for listening.
Instructions for manual, TUNE-O-MATIC, and AUTOSCAN tuning methods for FM and AM reception.
Detailed explanation of the electronic FM tuning mode for automatic station scanning.
Adjusting bass and treble for optimal sound quality based on program material and room acoustics.
Steps to connect a magnetic cartridge record player or changer for audio playback.
Instructions for connecting tape units for recording and playback.
Step-by-step guide to safely replace a blown power fuse to restore receiver operation.
To Next Page
