Need help?Do you have a question about the Fisher 220T and is the answer not in the manual?
General| Frequency Response | 20Hz to 20kHz |
|---|---|
| Total Harmonic Distortion | 0.5% |
| Tuning Range | FM, MW |
| Signal to Noise Ratio | 70dB |
| Speaker Load Impedance | 4-16 ohms |
Procedure for correctly routing the dial cord for tuning mechanism.
Steps to replace tuning meter, stereo beacon, and dial lamps.
Methods for cleaning the dial glass and front panel.
Procedures for multiplex alignment, stereo beacon, and distortion/power tests.
Steps for aligning the FM receiver front end stages.
Procedure for aligning the FM Intermediate Frequency amplifier.
Steps to calibrate the FM tuning indicator meter.
Procedure to adjust the FM muting sensitivity.
Steps for aligning the AM receiver front end stages.
Procedure for aligning the AM Intermediate Frequency amplifier.
Procedure to adjust the bias for the predriver/driver stages.
To Next Page
