Need help?Do you have a question about the Fishman AURA ACOUSTIC IMAGING PEDAL and is the answer not in the manual?
General| Type | Acoustic Imaging Pedal |
|---|---|
| Technology | Aura Acoustic Imaging |
| Inputs | 1 x 1/4" (instrument) |
| Current Draw | 200 mA |
| Bypass | True bypass |
| Blend Control | Yes |
| Power Supply | 9V DC power supply (included) |
| Controls | Blend, Volume |
| Effects | Acoustic Imaging |
| Features | 16 Aura Images |
Install a 9V battery or adapter. Pedal powers up when plugged in.
Set Volume to minimum, Select to #1, and Blend to mid-point for initial setup.
Play hard and adjust input trim so clip/batt LED flashes occasionally for optimal level.
Raise volume and audition the 16 Images using the select knob to find desired tone.
Adjust the blend knob for the desired mix of pickup and Image sound.
Adjust input level for pickup optimization. Set so clip/batt LED flashes occasionally.
Set as high as possible without clipping; reduce if distortion or clip/batt light flashes.
Adjusts the mix between Aura Image and pickup signal. 50/50 at 12 o'clock.
To Next Page
