Charging
Charging and operation assume installation and wiring as described in the Installation Guide,
available at http://www.shman.com/support/
We recommend fully charging the battery pack before using it for the rst time. Connect the USB
charge cable to the battery pack and plug into a wall socket using a 5 volt USB-compliant charger. The
LED on the battery pack will change from red to green when the charge is complete. Allow 3 hours for
the battery to reach full charge. Note that non-USB-compliant chargers may take longer than 3 hours.
The battery charge LED indicates the following battery conditions:
Normal operation
No Light Normal. May also indicate a completely discharged battery.
Blinking Red Low battery. Connect your charger.
USB Charger Connected
Steady Red Charging.
Steady Green Fully charged.
3
To Next Page
Loading...
