Need help?Do you have a question about the Fishman FLUENCE KEITH MERROW and is the answer not in the manual?
General| Active/Passive | Active |
|---|---|
| Number of Conductors | 4 |
| Noise Rejection | Excellent |
| Color | Black |
| Artist Series | Keith Merrow |
| Wiring | 4 Conductor |
| Configuration | Humbucker |
| Position | Bridge |
Plan control placement and test fit components for proper installation.
Fluence pickups require a 9V power supply, with options for batteries or rechargeable packs.
User assumes risk for installation and misuse, releasing Fishman from liability.
Feature for darker tone, activated by connecting HFT pad to ground.
Connect this pin to ground via switch or soldering to select Voice-2.
Connect pin to ground via switch to select Voice-3, overriding Voice-1/2.
Use three solder pads to select active coil in Single Coil / Voice-3 mode.
Access south coil output for HSH/HSS combinations, allowing hum-cancelling.
DC power input pin, compatible with 9V or 18V supplies for dynamic range.
Main output pin with 2k ohm impedance, suitable for low impedance pots.
To Next Page
