Fluence Classic Open Core – Connection Points & Functions
1. HFT (High Frequency Tilt) - This feature is for players who prefer a
darker top end, similar to the effect of using passive pickups loaded
by a long instrument cable.
To activate, connect the HFT contact pad to ground either wired
through a switch or permanently by creating a solder bridge to the
GND pad next to it.
The HFT pad is carrying signal. To prevent unwanted interaction, it
should not share a switch contact with any other HFT or voice select
wire.
2. Voice-2 Select Wire - To select Voice-2, connect this pin to ground
through a switch contact or permanently by soldering it to any
ground or by using one of the included jumpers across the pins.
6
SCO
Rev 2.0
GND
Keith Merrow Bridge
+9-18V
OUTPUT
GND
Single Coil
GND
Voice 2
Single Coil Mode Select
Neck
Bridge
GND
HFT
1
2
3
6
7
4
5
To Next Page
Loading...
