The active coil is selected by a solder bridge connecting the corresponding outer pad
to the center one.
The pickups ship from the factory with the inner coils (when used as a Bridge/Neck
pair) set as the default. To change the active coils to the outer ones, remove the solder
bridge and create a new one from the other outer pad to the center. To avoid dam-
aging the pads, solder wick or a desoldering pump are strongly recommended for
removing the solder bridge.
5. SCO (South Coil Out) - This solder pad is used to conveniently access the south coil
output on each pickup for HSH (Humbucker, Single, Humbucker) and HSS pickup com-
binations using the Fluence SSA Single width pickup.
The south coil is on the neck side of each pickup. The SSA pickup is a north coil, allow-
ing hum cancelling combinations in the 2&4 positions on a 5-way pickup switch.
8
To Next Page
Loading...
