6
Installation
This guide provides installation instructions for the Fishman Fluence Universal Battery Pack intended
for use with the Fishman Fluence series of pickups.
Warning! Installation of this product is meant to be performed only by a professional instrument
repair technician.
1. Connect the battery pack to the recharge module and choose their desired location. Determine
the best route for the power leads inside the instrument body. Ensure the components will t in the
selected locations or modify the instrument until the t is correct.
2. Review your planned scheme for issues.
3. Most battery packs are designed for drop-in replacement in standard guitar models. For the Universal
Battery pack, drill a 1/2 inch hole through the control panel cover in your chosen location. Remove the
adhesive backing from both the battery and recharge module and then press them into place. See the
following pages for details.
4. Solder the recharge module power leads and test your completed installation before nishing
assembly.
To Next Page
Loading...
