4
Getting Started
Here are some basic setup tips to help get you going. To operate your
SA220 safely, please read the entire manual, especially the Important Safety
Instructions on page 2.
Setting the SA220 on its Stand
SA220 is intended for use with the included tripod speaker stand in portable
applications where the amplifier and stand are to be placed directly on a level,
solid, flat surface. Do not substitute the speaker stand with a non-Fishman
part or attempt to mount or suspend the SA220 in a permanent or temporary
method other than that as described in this guide or by Fishman.
1. Locate the stand in a place that is free of obstructions, where it may be
accidentally pushed over, or where it may be a trip hazard.
2. Loosen the lower of the two large thumbscrews and spread the tripod legs.
Follow the height warnings printed on the stand for safe operation
(Figure 1). Setting the height outside this area is forbidden.
Tighten the thumbscrew before placing the SA220 on the stand.
3. Remove the safety pin and loosen the top large thumbscrews. Extend the
top tube to the third hole or lower if you are seated while performing.
Replace the safety pin. Allow the tube to rest on this pin and tighten the
top thumbscrew (Figure 2).
4. Lift the SA220 using the handle on the back of the unit while supporting
the weight with your other hand. A guide is molded into the underside
of the SA220 and acts as an aid in positioning the SA220 onto the tripod.
Once positioned, lower the SA220 onto the tripod until it rests firmly on
the tube.
Loosen Tighten
Max. stand diameter: 43inches / 110cm
Safety Pin
Figure 1. Figure 2.
Warning: Follow the height warnings
printed on the stand for safe
operation. Setting the height outside
this area is forbidden.
To Next Page
Loading...
