8
Controller Installation - Option 2
Mounting the Connect controller directly on your guitar’s body
In some cases the controller will need to attach directly to the guitar in order to
make sure the wire attached to the pickup has enough length to allow the pickup
to sit underneath the strings as close to the bridge as possible. Checking this
length will help determine whether or not the endpin bracket can be used. The
majority of electric guitars will be able to accommodate the endpin bracket
without any issues. Large hollow body electric guitars and acoustic guitars may
require the magnetic bracket to attach directly to the guitar.
1. Determine your ideal controller position.
2. Remove the controller and clean the application area with a soft lint
free cloth.
3. Press the controller and mount together so that the magnets “click”
into place.
4. Peel the adhesive from the controller mount.
5. Carefully position the controller at your ideal position, and then press
the controller and controller mount against the guitar top. (Fig 2)
6. Remove the controller and verify that the controller mount is securely
attached to the guitar, burnishing the mount and adhesive to the guitar
with your thumb.
To Next Page
Loading...
Need help?
General
