4
For more detailed instructions please visit www.fishman.com/tripleplay
TriplePlay Hardware Installation Quick Start
Installation overview. You’ll be attaching both the TriplePlay controller and hexaphonic pickup to your
guitar. This is a quick overview - see the online documentation for more detailed instructions. Note that the
installation may require slight adjustment to your guitar. If you are not comfortable with these procedures,
please consider using a professional technician to complete your installation.
Mounting the TriplePlay Controller: There are two different ways of mounting the controller on your
guitar, both of which use the Magnetic Ring Mount. This ring mount is adhered either directly to the face of the
instrument (“Direct mount” method), or onto one of the End-Pin Brackets (“End-Pin Bracket mount” method),
which allows for a completely non-invasive installation. Most users select the end-pin bracket mounting
method, but direct mounting can be useful for installing the controller in unique locations upon the instrument.
Option 1
Option 2 - recommended method
Direct Mount - Select a location on your guitar and test the placement of the
controller to ensure a good fit, then simply remove the adhesive backing from
the Magnetic Ring Mount, place the mount adhesive-side down directly onto
the surface of your guitar, and press firmly for 30 seconds.
Note: The adhesive used for this method is removable, but please use caution
when doing so in order to protect the surface finish of your instrument. Sliding
dental floss along the underside of the adhesive is an effective method for
removing the bracket.
End-Pin Bracket Mount - This method allows you to mount the controller
without applying any adhesive to your guitar. Your TriplePlay controller comes
with two End-Pin Brackets: a right-angled bracket for flat-topped guitars, and
a slanted one for curved-topped guitars. Select which bracket best fits your
guitar, and refer to the next page for installation instructions.
To Next Page
Loading...
