Center and Install Frame Canopy to Legs: Center the Canopy Frame over the Upper Leg
Clamps for final installation. Start but do not tighten each Item 5 bolt into the Side Upright
Caps then tighten the bolts keeping the gap on each side of the clamp equal.
Center Cover to Canopy Frame: The next step is to center the cover onto the Canopy
Frame with the Sunbrella label to the rear of the boat. Use tie wraps, zip ties or rope on
each corner as shown below, as well as one each side keeping the gap between the fabric and
frame equal all around.
Lace Cover to Canopy Frame: The next step is to lace the cover onto the Canopy Frame.
We recommend putting the canvas in place being held by 10 -12 zip ties. Start in the center at
the front of the T-Top and tie off the rope to the frame or as shown. Then lace half of the fabric
to the center in the back snug but not tight enough to move the fabric. The second half of the
lacing will be done tighter to tension the fabric.
There should be approximately ½ inch space between canvas and rail once complete.
Remove the zip ties once cover is completely laced onto the frame and tightened.
To Next Page
Loading...
