11
Regulatory & Safety Notices
Model Name: FB202
The scale measures body fat using bioimpedance analysis. ITO electrodes form a
pattern on the top of scale, and send a small, safe signal through the body to measure
impedance.
Type BF Applied Part
This symbol indicates that the surface scale is a Type BF applied part intended to
deliver an electrophysiological signal to and from the user. The scale measures body
mass using bioimpedance analysis. ITO electrodes form a pattern on the top of scale,
and send a small, safe signal through the body to measure impedance.
Aria 2 is not considered a medical device in all countries below except for the U.S.
USA: Federal Communications Commission (FCC)
statement
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
This device may not cause harmful interference and
This device must accept any interference received, including interference that may
cause undesired operation
FCC Warning
Changes or modifications not approved by Fitbit, Inc. could void the user’s authority
to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
To Next Page
Loading...
