Important Note:
For the 1000 gph filter pump, please make
sure to plug the hoses completely into the
inlet outlet pipe opening as shown in figure:
Step 20: Filling the swimming pool with water.
After installation is complete, and before filling with water, make sure that
all connections are correctly fastened and that there are no cracks or holes.
After passing inspection, add water until the water level reaches engraved
line on the liner.
Please note that water will naturally accumulate on the bottom during
filling. If you see small puddles near the floor of the pool, it is a good
chance it is not a leak or puncture because the liner is very strong. In the
unlikely event of an actual puncture, the water level will drop down by
about at least an inch a day.
Figure 2: Example of a non-leak due to filling
Completed installation shown in figure below:
THE IPOOL INSTRUCTION MANUAL
Pool Set-Up
Please carefully read this instruction manual
before installing and using the iPool
22
To Next Page
Loading...