L O U D S P E A K E R
C O N N E C T I O N S
In 4-channel operation (for example, one loudspeaker on each amplifier channel), the impedance
must not be lower than 2 ohms for each speaker
In bridging mode (two amplifier outputs bridged) the impedance must not be lower than 4 ohms for
the bridged output.
Never connect loudspeaker cables with the ground of the chassis or the +12V DC supply voltage.
If the amplifier is operated with a too low impedance or incorrectly used, the entire sound system
may be damaged. This means a warranty void in such cases.
12
To Next Page
Loading...