X7 bite alarm- switching on / off:
■ To turn on the bite alarm: Set the switch to ON position (the lever up).
■ To turn off the bite alarm: Set the switch to OFF position (the lever down).
MUTE (to switch off the sound and the transmission temporarily):
To turn on the MUTE function:
■ Briey press the FC function button.
■ The MUTE function is indicated by the middle LED ashing.
To turn off the MUTE function:
The function is cancelled automatically after 30 seconds after the last sh-line
movement or can be switched off by pressing the FC button.
Night position LED (NIGHT):
To turn on the NIGHT function:
■ Press the FC button for 2 sec.
■ Activation (deactivation) of the NIGHT function is signaled by a short beep sound.
■ The green position LED at the top will lights up dimly.
Termination of the NIGHT function:
Same procedure as for the switch on function. Or switch the bite alarm off (lever to the
OFF position).
RGB LED colour and brightness adjustment, full switching-off of LED (discrete mode):
To turn on the RGB function:
■ Press the FC button for 5 sec.
■ After a while, the signaling LEDs start “running” up and down.
■ Now, you can choose the colour by turning the “S” button.
■ By turning the “T” button adjust the brightness of the LED or turn off the LED
completely.
To turn off the function for LED colour and brightness choice:
The function can be turned off by briey pressing the FC button or by switching off the
indicator (the lever down, OFF position).
Fluctuating beep at high-speed ride:
Fast unwinding of the line is signaled by a long-drawn tone. You can activate more
signicant signaling the fast unwinding of the line (the ride) by a uctuating beep:
Switching on/off the uctuating beep at the ride:
■ Press the FC button 10 times in rapid succession.
■ A short beep sounds, and the green LED ashes shortly.
■ To switch the function off, use the same procedure.
2
+420 731 115 151 | flacarp@tfe.cz | www.flacarp.com
2
BITE ALARM - FUNCTION DESCRIPTION
To Next Page
Loading...