Flagro F-1000T - Specifications

- 3 -
This heater is designed and approved for use as a
construction heater under ANSI Z83.7 2000 and
CSA 2.14 2000 Gas Fired Construction Heaters
We cannot anticipate every use which may be made
of our heaters. CHECK WITH YOU LOCAL FIRE
SAFETY AUTHORITY IF YOU HAVE QUESTIONS
ABOUT APPLICATIONS.
Other standards govern the use of fuel gases and heat
producing products in specific applications. Your local
authority can advise you about these.
SPECIFICATIONS
Model ……………………………………………………. F-1000T
Input ……………………………………………………... 1,000,000 btuh
Fuel ……………………………………………………….. Natural Gas or Propane
Inlet Pressure …………………………………………….. Natural Gas: 7.0” W.C.
………………………………………………… …... Propane: 11” W.C.
Ignition …………………………………………………….. Direct Spark Ignition
.…………………………………………...….. Thermostat Control
Air Circulation …………………………………………….. 7000 cfm
Fuel Consumption ……………………………………...... 46 lbs/hr
……………………………………………... 952 cfh
Approved ………………………………………………...... cULus listed