Flama 1317FL - Control Panel

25
English
ATTENTION:
The dehumidier must be placed in a
vercal posion for at least 12 hours
before use.
Do not aempt to replace the power cord
or plug, as this is a dangerous operaon.
Have them replaced immediately by a
Flama-authorized technical assistance
service or by similarly qualied technicians
to prevent danger.
DESCRIPTION
1. Control panel
2. Indicator light
3. Lateral grille
4. Water tank
5. Filter compartment
6. Filter
7. Plug for connuous drainage
8. Handle
9. Wheels
10. Display
11. Power buon (ON/OFF)
12. Mode buon
13. Humidity control buon (HUM)
14. Timer buon (TIMER)
15. Fan speed buon (SPEED)
16. Lock buon (LOCK)
OPERATING INSTRUCTIONS
CONTROL PANEL
POWER buon (11) - turning the
appliance on and o
Ensure that the water tank is in the correct
posion (aer turning on the appliance
for the rst me, if the full tank indicator
lights up, remove the tank and return it to
the correct posion).
Check that the appliance is plugged into
the wall outlet.
Aer connecng to the power source, all
the indicators and the display will light up
for 1 second and then turn o. Following
an alert sound, the power indicator will
light up and the dehumidier will enter
standby mode.
Press the POWER buon and the
dehumidier will begin working, with
an inial humidity of 60%, in standard
automac mode and high fan mode.
Press the POWER buon again and the
dehumidier will stop working.
Disconnect the appliance from the power
supply, unplugging it from the wall outlet.
MODE buon (12)
Press the buon to change the appliance’s
use mode; the corresponding indicator will
light up.
Automac mode
When the ambient humidity ≥ the dened
humidity + 3%, the fan will begin to