Flama 1643FL - Cleaning and Maintenance

22 www.ama.pt
CLEANING AND MAINTENANCE
Unplug the charger from the wall outlet
and let it cool down before beginning any
cleaning operaon.
Clean the appliance with a damp cloth
and a few drops of detergent, drying it
immediately aerward.
Do not use solvents, products with acidic
or basic pH, such as bleach, or abrasive
products to clean the appliance.
Never submerge the appliance in water or
any other liquid, and do not place it under
running water.
NOTE - as can occur with any painted parts,
with use and aer a certain period of me
the paint will begin to wear away. This is
normal and does not aect the appliance’s
performance. Some hand creams and
disinfectants can accelerate this process.
Emptying the dust bin
Empty the dust bin when it is full or when
there is a noceable reducon in the
appliance’s sucon strength.
Remove the accessories from the bin’s air
intake.
Open the lid of the bin by pressing the bin
lid buon and empty the contents into an
appropriate waste container.
Cleaning/substung the lter
It is recommended to periodically check the
state of the dust bin HEPA lter (a highly-
ecient air lter that eecvely captures
spores, ashes, mites, pollen, etc.) and to
substute it aer every 50 hours of use.
Remove the dust bin by pressing the bin
release buon.
Turn the dust bin clockwise.
Remove the metallic lter, the HEPA lter
and the HEPA lter enclosure.
To remove the HEPA lter, gently turn it
to the right to remove it from the metallic
lter.
Remove the HEPA lter enclosure.
Wash the enclosure and the HEPA lter
with water.
Allow the HEPA lter and the lter enclosure
to dry completely before reassembling.
Proceed in reverse order to mount the
HEPA lter to the metallic lter. Make sure
you have already assembled the HEPA lter
enclosure.
Place the metallic lter inside the bin and
mount the dust bin as described in the
“Assembling the dust bin” secon.
Cleaning the brushes
At the boom of the mul-surface
motorized cleaner head, slide the rotang
brush release buon outwards to remove
the rotang brush. Remove the rotang
brush and clean it.
To re-assemble it, follow the direcons
above in reverse order.
Clean the mul-surface motorized cleaner
head with a damp cloth and a few drops of
detergent, drying it immediately aerward.
CONSUMABLES
All consumables (lters, etc.) for your
appliance model may be acquired from
authorized distributors and establishments.
Always use manufacturer consumables
designed specically for your appliance
model.