Flama 1643FL - Operation

21
English
Plug the charger connector into the socket
on the back of the appliance.
While the baery is charging, the pilot light
will turn on to indicate that the charger is
charging the baery.
Remove the baery from the charger aer
the specied amount of me.
Once charging is complete, unplug the
charger from the wall outlet.
Note: Do not use the appliance while it is
plugged in.
Note: For a long useful baery life, it is
recommended that you only charge the
baery once it is fully depleted.
Use indicator
The use indicator indicates the baery
status:
Flashing red - the baery needs to be
charged.
Steady red - the baery is low.
Steady green - charge complete.
Assembling the mul-surface motorized
cleaner head and accessories (Fig. 3)
Fit the wand, mul-surface motorized
cleaner head or the accessories into the
wand/accessory connecon or into the end
of the wand.
WARNING
Press and hold the accessory release
buon while ng or removing the tube
or accessories. Do not force any of the
components, as this could damage the
appliance.
OPERATION
Use/baery indicator
The use indicator indicates the baery
status:
Flashing red - the baery needs to be
charged.
Steady red - the baery is low.
Steady green - charge complete.
Before rst use
Before using the product for the rst me,
it is important to let the baery charge
completely.
Prepare the appliance according to the
desired vacuum funcon.
Use
Press the ON/OFF buon to start the
appliance (the use/baery indicator will
light up) and vacuum at moderate strength.
Press the buon again to vacuum at
maximum strength.
Pressing the buon again will turn o the
appliance.
Aer use
To remove the wand and the accessories
from the vacuum cleaner, press the
accessory release buon and pull.
Remove the baery from the appliance if it
will not be used for a long period of me.
Clean the appliance.