Flama 1676FL - Vacuum Assembly; Cleaning and Maintenance

13
English
DESCRIPTION
1. ON/OFF buon
2. Cord retracon buon
3. Sucon power regulator
4. Flexible tube
5. Telescoping tube
6. Mul-surface brush
7. Parquet brush
8. Crevice brush tool
9. Bag status indicator
10. Release pedal
VACUUM ASSEMBLY
Remove all components from the packaging.
Aach the exible tube to the vacuum body,
making sure it is fully inserted and secure.
Fit the handle of the exible tube into the
telescoping tube.
Fit the desired accessory onto the end of
the telescoping tube.
The mul-surface brush has two posions,
one for so surfaces and one for hard
surfaces. The crevice brush tool is used for
narrow, dicult to reach surfaces.
OPERATING INSTRUCTIONS
Before use
Make sure to only use the appliance if
all the included lters and dust bag are
correctly installed. An incorrectly installed
or damaged dust bag or lter can damage
the appliance.
Use
Extend the power cord and connect the
plug to a wall outlet. Do not pull the cord
beyond the red marker.
Adjust the telescoping tube to the desired
length.
Select the type of ooring to vacuum using
the mul-surface brush:
Hard ooring – Lower the brushes to
protect the ooring.
Carpets – Raise the brushes for deep
cleaning.
Parquet Brush - for parquet oors and
other sensive oors. Turn on the vacuum
by pressing the ON/OFF buon.
Slide the sucon power regulator to
increase or decrease sucon.
Turn o the vacuum when done using by
pressing the ON/OFF buon.
Remove the plug from the wall outlet.
Press the cord retracon buon to retract
the cord back into the vacuum.
To move the appliance between rooms,
unplug it from the wall outlet and transport
it using the handle. Never pull the appliance
by the power cord to move it.
CLEANING AND MAINTENANCE
The plug needs to be removed from the wall
outlet before performing any maintenance
or replacing any parts.
Turn o the vacuum when done using by
pressing the ON/OFF buon and unplug it
from the wall outlet.
Clean the exterior of the vacuum with a
so, damp cloth followed by a so, dry
cloth.
Never use harsh liquids to clean the
vacuum.