Flama 2221FL - Troubleshooting

14 www.ama.pt
Release the ON/OFF buon; the device
stops.
NOTE - Keep the device in a vercal posion
unl the desired result is achieved, without
exceeding the maximum operang me (1
minute).
Unplug the appliance from the mains.
Detach the blade holder and bole from the
base motor by turning it counterclockwise
to the unlocked posion.
Unscrew the blade holder from the bole.
Be careful when handling the blade holder,
they are sharp and can cause injury.
You can conserve the mixture by screwing
the cap onto the bole and using the
opening for easy access to the contents.
ATTENTION – Do not start the appliance
with an empty or overlled bole, as this
could damage the motor.
ATTENTION: The operang me must never
exceed 1 minute.
TROUBLESHOOTING
Problem cause soluon
The appliance does not
work aer turning the ON/
OFF buon.
The appliance is not
plugged into the mains.
Connect the appliance to
the mains.
The blade assembly is not
correctly connected to the
cup.
Follow the instrucons in
the Use chapter.
During operaon, there is a
slight burning smell.
First uses.
It is a normal situaon,
which will disappear aer
the rst few uses.
Base motor is overloaded.
Respect the quanes
indicated.
The device switches o
during operaon.
Motor overheang.
Unplug the appliance from
the mains and wait 30
minutes before plugging it
in again.
Blades do not rotate.
Poor appliance assembly.
Follow the instrucons in
the Use chapter.
Pieces too big.
Cut the ingredients into
smaller pieces.
The bole leaks. Poor appliance assembly.
Follow the instrucons in
the Use chapter.