Flama 2386FL - Troubleshooting Tips; Cleaning and Maintenance; Restart Instructions

16 www.ama.pt
Thermostat Instrucons
Note - Make sure the thermostat
adjustment knob is in the MAX posion
before switching on the appliance.
Once the compartment has reached
the desired temperature, slowly turn
the thermostat adjustment knob
counterclockwise unl you hear a
slight sound. Then turn the thermostat
adjustment knob clockwise unl you
hear a slight sound again. The appliance/
thermostat switches on and o to ensure
the desired temperature.
To turn o the device, turn the Power &
Mode rotary knob to the o posion (0).
Then remove the plug from the socket.
To adjust the thermostat knob, turn the
thermostat adjustment knob clockwise
to increase the desired temperature.
Turn counterclockwise to decrease the
temperature.
NOTE: It is normal for the appliance to
turn on and o as it maintains a xed
temperature.
SAFETY FEATURES
The device is equipped with thermal
overload protecon to prevent overheang.
The appliance switches o automacally
when it reaches an excessive temperature
and will only start again if the user restarts
the appliance (see RESET INSTRUCTIONS)
RESTART INSTRUCTIONS
Unplug the appliance and wait 15 minutes
for the appliance to cool down.
Aer 15 minutes, turn the device back on
and operate normally.
TROUBLESHOOTING TIPS
if your appliance unexpectedly shuts
down or stops working, this may be due to
acvang one of the aforemenoned safety
features to prevent overheang.
Make sure the power plug is plugged into a
working electrical outlet.
Make sure the power plug is plugged into a
working electrical outlet.
CLEANING AND MAINTENANCE
WARNING - Always disconnect the plug
from the power outlet before carrying out
any maintenance and cleaning operaons.
IMPORTANT! DO NOT IMMERSE THE
APPLIANCE IN WATER!
Clean the grill with the help of the vacuum
cleaner and the brush aachment. This will
remove grime and dirt from the inside of
the heater.
DO NOT ATTEMPT TO DISASSEMBLE THE
APPLIANCE. Clean the outside with a so
cloth.
DANGER: Do not use gasoline, benzine,
thinner, abrasive cleaning uids, etc. as
these will damage the convector. NEVER
USE ALCOHOL OR SOLVENTS.
To store the device, place it together with
these instrucons in its original box in a
cool, dry place.