Fit the hose to the appliance using a spanner to tighten it onto the connection thread. If the hose is
replaced it must be secured to the appliance and regulator connections permanently. Disconnect
the regulator from the cylinder (according to the directions supplied with the regulator) when the
barbecue is not in use.
The Barbecue must be used in a well ventilated area. Do not obstruct the flow of combustion air
to the burner when the barbecue is in use. ONLY USE THIS BARBECUE OUTDOORS.
BEFORE USE CHECK FOR LEAKS
Never check for leaks with a naked flame, always use a soapy water solution
TO CHECK FOR LEAKS
Make 2-3 fluid ounces of leak detecting solution by mixing one part washing up liquid with 3 parts
water.
Ensure the control valve is “OFF”.
Connect the regulator to the cylinder and ON/OFF valve to the burner, ensure the connections are
secure then turn ON the gas.
Brush the soapy solution onto the hose and all joints. If bubbles appear you have a leak, which
must be rectified before use.
Retest after fixing the fault
Turn OFF the gas at the cylinder after testing.
If leakage is detected and cannot be rectified, consult your gas dealer.
LIGHTING YOUR BARBECUE
Lighting Instructions
1. Open the hood.
2. Turn all the control knobs clockwise to “OFF” position.
3. Connect the regulator to the gas bottle. Turn the gas supply “ON” at the cylinder. Check
with the use of soapy water for any gas leakage between the bottle and the regulator
4. Push down the left hand control knob and turn it anti-clockwise to the “Full rate” position
whilst depressing the piezo ignition button 4 or 5 times. This will light the burner. Observe if
the burner has lit. If not repeat this process.
5. If the burner has not lit after retrying wait 5 minutes and repeat step 3.
6. Adjust the heat by turning the knob to the High/Low position.
7. If the burner does not light. Light the appliance with a match using the lighting hole in the
side of the appliance. Consult your gas dealer to rectify the ignition.
8. To light the right hand burner, turn the right hand control knob to the full rate position, it will
light of the left hand burner. Always light the appliance from the left hand burner to the right
hand side.
9. To turn the barbecue ‘OFF’ turn the gas control knobs to the ‘OFF’ position and close the
cylinder valve.
Warning: If the burner fails to ignite, turn the control knob off (clockwise) and also turn the
cylinder valve off. Wait five minutes before attempting to relight with ignition sequence.
CLEANING AND CARE
To Next Page
Loading...