Flame C-3 MK2 - Handling the C-3 MK2 Knob Recorder; Manual Mode (Stop); Recording Knob Movements; Playback Modes

6
3. Handling
For beginning the record sequence please push the REC button (blinking LED). You can record
the movements of the ruler until you push again the button REC or until up to the maximal
record time. Now the record sequence stops and jumps automatically in the Play loop mode
(LED on).
Track 1 has an additional CV-1 input (0 .. + 10V or +/- 5V). They switch between the two sour-
ces by their activity: When turning the potentiometer, the potentiometer voltage is taken, when
changing the CV-1 voltage, this voltage is taken.
You can record the CV-1 input voltage curves of z.Bsp. Record LFOs between 0 and + 10V (or
+/- 5V). The sample rate is about 300Hz. Pot one serves like an offset ruler.
From mode STOP or PLAY you can start a record sequence anytime.
The maximum recording time per channel is about 1 minute.
After power on the module stands in STOP mode. All LEDs are off. With the pot you can adjust
an output voltage between 0 and +10V. Track 1 can alternatively output and record a voltage
applied to the CV-1 input. They switch between the two sources by their activity: When turning
the potentiometer, the potentiometer voltage is taken, when changing the CV-1 voltage, this vol-
tage is taken. You activate the manual mode by pushing the button STOP.
After a record sequence the play back of the track starts automatically in loop (LED on). If you
are in mode STOP (LED off) then you can start the play back with pushing the button PLAY.
Please note the both versions of pushing (short or long):
ONE SHOT - Track plays once only: Push the button shortly (< 0,5sec)
PLAY LOOP - Track plays in loop: Push the button longer (> 0,5 sec)
ATTENTION:
Reset can start the track (or tracks) while Play mode is activated (LED on).
3.2 Record
3.1 Manual mode (Stop)
3.3 Play back