20
LFO - RATE (speed)
LFO - SYNC (Synchronization, triggers)
The speed of the LFO is set in the RATE menu. In the SYNC submenu you can specify
whether the LFO should run freely or be synchronized to the clock. The speed in free-run-
ning mode can range from several minutes duration to the lower audible audio range
around 60Hz.
Press the RATE button once. The button now lights up. After releasing the button, the cur-
rently set value is shown on the display. Change the value using the dial.
Depending on the SYNC setting (see LFO - SYNC section), different value ranges are
shown in the display:
With SYNC = oFF
(Synchronization switched off, LFO free running)
Value range: 000...120
000 Speed a few minutes duration (approx. 9:50min)
120 Speed approx. 40Hz
With SYNC = on
(Synchronization switched on, LFO runs at musical intervals)
In the SYNC submenu you can specify whether the LFO should run freely, be synchroni-
zed to the clock (in a loop) or be triggered by notes on a track.
The Menu SYNC is the submenu of Menu RATE.
Press and hold the RATE button for approx. 1sec. When the button flashes, release it
again. The current setting for the synchronization of this LFO is shown in the display.
Change the value using the DATA knob.
Value range: on / oFF / tr1..tr8
on Synchronization to the clock is switched on, the LFO is synchronized to the clock
oFF Synchronization to the clock is switched off, the LFO is free running
tr1..tr8 LFO wave is triggered by notes on a track (syncted OneShot)
4 4 bars
3 3 bars
2 2 bars
1 1 bar
_2. half dotted
1t 1 bar triplet
_2 half
_4. 4th dotted
_2t half triplet
_4 4th
_8. 8th dotted
_4t 4th triplet
_8 8th
16. 16th dotted
_8t 8th triplet
16 16th
16t 16th triplet
32 32th
To Next Page
Loading...
